appears next to the status code to indicate that more
information is available. Place your cursor over the icon to view the
message. When viewing the web application scan results, the message appears
in parentheses after the status code.Note: This information applies when WAS 1.0 is enabled for your subscription.
The web application scan status is provided in the WAS scan history list and in web application scan results.
When viewing the WAS scan history list, a warning icon appears next to the status code to indicate that more
information is available. Place your cursor over the icon to view the
message. When viewing the web application scan results, the message appears
in parentheses after the status code.
The table below describes the status code/message combinations for web application vulnerability scans and discovery scans.
Status code |
status Message |
notes |
Scan Results |
Submitted |
<None> |
A scan request was submitted, and the scan is not started yet. (Appears only in the WAS scan history list.) |
<None> |
Running |
<None> |
The scan is running. (Appears only in the WAS scan history list.) |
<None> |
Canceling |
<None> |
The scanning engine is in the process of canceling the scan. (Appears only in the WAS scan history list.) |
<None> |
Canceled |
Scan has been canceled |
The scan was canceled successfully. |
Partial |
Finished |
<None> |
The scan completed successfully. For a vulnerability scan: The full scan results include vulnerability detection data, if any. For a discovery scan: The full scan results include discovery detection data, if any. |
Full |
Finished |
No host alive |
The scanning engine did not find the host to be up and running. |
Empty |
Finished |
Time limit exceeded |
The scan duration exceeded the time limit. |
Partial |
Finished |
No web application detected |
The scanning engine did not detect the target web application. Scan results will include any information gathered data collected. |
Information Gathered |
Error |
Scan could not be launched |
The scanning engine failed to launch the scan. Please contact Support for assistance. (Appears only in the WAS scan history list.) |
<None> |
Error |
Scan results could not be processed |
The scanning engine failed to process the scan results. Please contact Support for assistance. |
Empty |
Error/Interrupted |
Scan did not complete successfully |
The scanning engine failed to complete the scan. Please contact Support for assistance. |
Empty |